Valtari

Yes, the Valtari is a hardwired ceiling fitting and must be installed by a qualified electrician under UK Building Regulations Part P. The installation involves connecting mains wiring directly into the fitting and cutting a 68mm hole in your plasterboard ceiling. While rated as moderate difficulty, it's not a DIY job unless you're a certified sparks.

Yes, with an IP65 rating this downlight is fully protected against water jets and is suitable for bathroom zones 1 and 2. You can safely install it directly above a bath or shower enclosure. The fire-rated design also helps maintain the integrity of your ceiling if it separates habitable spaces.

This is an integrated LED fitting, meaning the LED is built in and cannot be replaced. However, quality integrated LEDs typically last 25,000–50,000 hours (roughly 15–30 years under normal use), so replacement is rarely needed within the 2-year warranty period or well beyond.

Yes, the Valtari is dimmable, but you'll need a compatible LED dimmer switch — older incandescent dimmers often cause flickering or buzzing with LED fittings. Check that your dimmer is rated for LED loads and has a minimum wattage threshold below 7W, as some LED dimmers won't operate reliably with such low-wattage fittings.

This fitting has switchable CCT (correlated colour temperature) ranging from 2700K warm white to 6000K daylight white. The colour is typically changed via a small switch on the driver unit or rear of the fitting before installation, so you'll need to decide your preferred temperature during fitting. Refer to the installation guide included in the box for the exact mechanism.

Yes, the ultra-slim 32mm height makes the Valtari ideal for shallow ceiling voids or where insulation sits close to the plasterboard. You'll need a 68mm diameter cut-out and at least 35–40mm of clearance above the ceiling to accommodate the driver and allow heat dissipation, but this is significantly less than most standard fire-rated downlights which often require 70mm+ depth.